![background image](http://html1.mh-extra.com/html/amx/and-nmx-dec-n2235/and-nmx-dec-n2235_instruction-manual_2938518013.webp)
Installing and Configuring Your AV Equipment
13
N2000 Series User Manual
Installing and Configuring Your AV Equipment
This chapter provides an installation overview as well as a detailed step-by-step process for installation. If you encounter any
problems, refer to the
Troubleshooting
section on page 66 for help.
Installation Overview
The N2000 Encoders and Decoders have multiple configuration and installation options. For basic installation guidelines, see the
table below. For more detailed instructions, refer to
Step-by-Step Installation Instructions
on page 16.
NOTE:
When the unit is not in use, remove the power cable and disconnect any other cables (e.g., Ethernet, audio, video) connected to
the Encoders and Decoders.
Basic Installation Guidelines
Connections
Options
Power
Power over Ethernet (PoE):
Connect the unit’s P0 port to an active, PoE-enabled network switch (not supported on
the N2212 Decoder).
External power supply:
If not using PoE for power, connect a 12V regulated power supply (part number N9312) to the
unit’s two-pin terminal block plug connector l12V 2A. Power supply is required for the N2212 Decoder.
Network
PoE units:
If using PoE to power the unit, you should already have a network connection.
Externally powered units:
If not using PoE, connect either the P0 or P1 port to the network using the appropriate
cable.
Daisy-chain configuration:
Once network connection is established to one unit, you can daisy-chain additional units by
connecting Ethernet cables between devices using their P0 and/or P1 ports. Keep in mind that the number of units
supported in this configuration is limited by bandwidth (total aggregate streams must be less than 1 Gb/s).
NOTE:
PoE power is only supplied to the unit connected directly to the network. All other units in the daisy-chain
must have an external power supply.
Video
N2000 Encoders
• For video encoding of a
digital
source, connect the source to the Encoder’s
HDMI IN
port using a video cable with an
HDMI connector (or adapter).
• For video encoding of an
analog
source, connect the source to the Encoder’s
VGA IN
port using a video cable with a
VGA connector (or component adapter).
N2000 Decoders
• For video decoding, connect a digital display to the Decoder’s
HDMI OUT
port using a video cable with an HDMI
connector (or adapter).
Audio
N2000 Encoders
• For audio encoding, connect a line level analog audio source to the
Audio
input terminal block plug connector, or
• Use the embedded audio from the video source.
N2000 Decoders
• For audio decoding, connect a line level analog audio device to the
Audio
output terminal block plug connector, or
• Send embedded digital audio (embedded in the HDMI connection) to a monitor’s speakers.