Installing and Configuring Your AV Equipment
19
N2000 Series User Manual
4.
Once the Decoders and displays are connected and powered up, the LocalPlay screen appears on the displays.
NOTE:
If the LocalPlay screen does not appear, refer to Chapter 5, Troubleshooting for more guidance.
NOTE:
In order for the unit to receive PoE, it must be connected to a switch or other equipment that has a PoE PSE (Power Sourcing
Equipment) port. The N2212 Decoder is not a PoE device. When using this product, you must also provide power using the 12V
external power supply (included in shipment). PoE does not pass through the daisy chain (P1) port.
CAUTION:
Do not run wiring that is connected to a PoE PSE port outside of the building where the PSE resides. It is for intra-building
use only.
Step 3: Connecting Encoders to the Network and Configuring Stream
Settings
1.
Using a Cat-5 cable, connect your SVSI Encoder’s
P0
port to a PoE-enabled switch. In non-PoE applications connect a 12V
regulated power supply (N9312) to the two-pin terminal block plug connector (labeled
+12V 2A
).
NOTE:
In order for the unit to receive PoE, it must be connected to a switch or other equipment that has a PoE PSE port.
2.
In
N-Able
, select the
Unit
Management
tab and click the
Auto
Discover
button (if the table has not already populated itself
with the installed units). See
Figure 6
.
FIG. 6
Unit Management Page
3.
Find your Encoder in the list. N2000 units are displayed on the following tabs:
•
Unit
Management
tab — N2000 units have
N2000 Encoder/Decoder
listed in their
Type
fields.
•
Video Matrix
tab — N2000 units are found on the
N2000
sub-tab (as shown in
Figure 7
).
NOTE:
If using multiple Encoders in your set up, it is important to plug in and configure one Encoder at a time. All Encoders come pre-
configured to use stream 1. As you add Encoders to the network, you will need to set them up to use different streams.