Encoder Configuration Options
35
N2000 Series User Manual
Status Section
The
Status
section of the
Settings
page is shown in
Figure 7
. Options are described in
Table 5
.
FIG. 7
Status Section
Netmask
View the current
Netmask
of the N2000 Encoder. When
in
STATIC
mode, enter a new
Netmask
into this field.
Gateway address
View the current
Gateway address
of the N2000
Encoder. When in
STATIC
mode, enter a new
Gateway
address
into this field.
Trial Save
Click to initially save IP address changes. Once you log
in to the unit using the new address, you will be able to
confirm and accept the changes permanently.
TABLE 4
Settings Page: Network Setup Settings (Cont.)
Option
Description
Notes
TABLE 5
Settings Page: Status Section
Option
Description
Notes
HDMI Status
Indicates if a video source is connected to the Encoder.
Input Resolution
Indicates the video resolution of the currently
connected source.
HDMI Status Pass Thru
Indicates if a display device is connected to the
Encoder.
Current Bandwidth
This is a snapshot of the unit as properties were loaded
to the browser, not a live counter. Refresh the page to
get an updated bandwidth.
Port 50001 Source IP
Shows the IP address of the currently connected device
or displays
Disconnected
if no connection exists.
Port 50001 can only accept a single external
connection at a time
. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Port 50002 Source IP
Shows the IP address of the currently connected device
or displays
Disconnected
if no connection exists.
Port 50002 can only accept a single external
connection at a time
. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Serial Source IP
Shows the IP address of the currently connected device
or displays
Disconnected
if no connection exists.
Only a single external connection can be accepted on
the port. If a device is currently showing the port
occupied (by a control system or other device), then
other connections will be rejected. However,
connection attempts from the same IP will override
the current connection.
Flush buttons
These buttons reset the port.
KVM IP
Shows the IP address of the KVM Decoder currently
connected to this Encoder.
This setting only applies to the N2135.