7.3.2 Measuring Cycle and Memory Activation
The measuring cycle is used for the storage of measured values, for averaging
and for the output of alarm values (also see manual 6.5.3).
Function MEAS.CYCLE:
MEAS.CYCLE
S Meas.Cycl 00:02:00
Example:
storing activated ´
S
´, meas.cycle 2 min
The meas.cycle is entered with 6 digits and format
hh:mm:ss
according to 5.4.
Clear meas. cycle and stop the measuring point scan with using the key
CLEAR.
The
storage activation
for all manual and cyclic measuring point scans (see
7.4.1) can be performed with the key
ON
.
Storage activation with key:
Switch-off with key:
ON
OFF
7.3.3 Conversion Rate, Continuous Measuring Point Scan
If required, the conversion rate can be increased from 2.5 to 10M/sec for each
module (man. 6.5, 6.5.4). For this purpose, with the switch position
MEAS.CYCLE, the additional function MEASURING RATE must be selected
with key
FUNCTION
and be entered by the keys
ENTER
,
,
ENTER
.
At the same time, the
continuous measuring point scan
can be set with the
identification code ´C´, i.e. not only the selected measuring point will be
scanned but all active measuring channels will be continuously scanned
successively (man. 6.5.1.3).
Function CONVERSION RATE:
MEAS.CYCLE
key:
FUNCTION
Meas. rate 10/s CS
Example:
conv.rate 10 M/s, continuously, with storing
Change meas. rate:
keys:
,
... or
... ,
ENTER
ENTER
The continuous storing
with the measuring rate ´
S
´ can be activated by using
the keys
ON
and
OFF
, while the output of the measured values ´
U
´ can only be
activated via the interface.
Storage activation with the key:
Switch-off with the key:
37
ALMEMO
®
5590-2
Cyclic Measuring Point Scan
OFF
ON
Summary of Contents for Almemo 5590-2 V5
Page 54: ...53 ALMEMO 5590 2 Appendix...
Page 55: ...ALMEMO 5590 2 54 Notes...
Page 56: ...55 ALMEMO 5590 2 Notes...
