AMR Almemo 5590-2 V5, Operating Instructions Manual, Page: 33 / 56

Display with measuring point designation
and device designation:
In case of a sensor breakage the short name of the measuring range and the
red control lamp
“
MEAS.VALUE
will flash instead of the measured value.
If the actual measured value is changed by scaling or correction values the
corresponding yellow lamps,
“ BASE and “ FACTOR will be on.
A re-programmed dimension is indicated by the control lamp
“
RANGE, UNIT
(s. 5.2).
Selecting a Measuring Point
The measuring points of all measuring modules can, directly or successively,
be selected with using the keys or
and the actual measured value will be
displayed. By selecting the measuring channel the input channel is, at the
same time, also selected (see 6.1).
Enter directly the meas. chan. (e.g. meas. point 12): , ,
CHANNEL
1 2
Increase measuring channel with key: (active channels only)
Decrease measuring channel with key: (active channels only)
7.1.2 Memory for Peak Values
From the measured values that are obtained from each measuring point the
maximum and minimum value is determined and stored each time. For
indicating the peak values the function MAX.VALUE or MIN.VALUE must be
selected with the rotary switch and the desired channel must be set.
Function MAX.VALUE or MIN.VALUE:
MAX.VALUE
MIN.VALUE
Clear: Key
CLEAR
01:Max.value: - - -
The peak values are also cleared when a total clearing (s. 7.) or change of the
meas. range is performed (s. 6.2). If the cleared channel is the selected meas.
channel, the meas. value will be indicated immediately after the clearing.
0012:Temperatur 123.45°C
Anlage 5590-2 Kühlraum
01:Max.value: 123.45°C
ALMEMO
®
5590-2 32
Continuous Measurement of a Measuring Point