E-3.
Circuit Descriptions
The circuit descriptions which follow are
referenced to Figures E-1, E-2, E-3 and the
schematic diagrams at the back of this manual.
In the following descriptions, references to
integrated circuits are given in the form "IC201-
1", which refers to Integrated Circuit 201, pin 1.
E-4.
Analog to Digital Conversion
The A to D conversion is done with a ICL8068
/ICL71C03 chip set. The ICL8068 takes care of
the analog part and the ICL71C03 takes care of
the digital part of the 4 ½ digit 20,000 count
dual slope conversion.
COUNTERS
DISPLAY
COMPARATOR
BUFFER
MULTIPLEXER
ZERO
CROSSING
DETECTOR
INTEG
UUT
CONTROL
LOGIC
INPUT
SWITCH
DC CONSTANT
CURRENT SOURCE
RANGE
SWITCH
MODEL 630ES OHMMETER BLOCK DIAGRAM
COUNTS
PHASE I
I0.00 I
I0.000
20.00 I
4 ½ DIGIT
PHASE II
PHASE III
NUMBER OF COUNTS TO ZERO CROSSING
PROPORTIONAL TO V
IN
AFTER ZERO CROSSING,
ANALOG SECTION WILL BE
IN AUTOZERO CONFIGURATION
BUSY
OUTPUT
INTEGRATOR
OUTPUT
CLOCK
AZ PHASE l INT PHASE ll DEINT PHASE ll AZ
INTERNAL
LATCH
POLARITY
DETECTED
ZERO CROSSING
OCCURS
ZERO CROSSING
DETECTED
Figure E1 - 630 Conversion Timing Diagram
