Model
SE578A
Service
Replacing Parts
Parts
7.
Cross Bar Assembly
Rev.
1
2
3
4
Procedure：
1.
Follow the procedures to left and right
Side Cases.
2.
Take Round Disk Cover apart and use
12mm wrench and 6mm Allen wrench
to release 5/16
"
x15mm Hex Head
Bolts together with 5/16
"
x35x1.5T Flat
Washers, which secure the Cross Bar,
as shown in figures 1 and 2.
3.
Use 13mm wrench to loosen M8 x
6.3T nut at outside and use 13mm
wrench together with M6 Allen wrench
to loosen the nut at inside to take apart
the Cross Bar, as shown in figures 3
and 4.
4.
To resume, install the Cross Bar on the
Crank Axle and lock with
Woodruff
Key, then reverse above steps to return
all parts.
