Model
SE578A
Service
Replacing Parts
Parts
11. Rear Rail Assembly and Incline Motor
Rev.
9
10
11
Procedures：
7.
Use 12mm wrench to release 5/16
"
x1
Hex Head Bolt and 5/16
"
x 35x2T flat
washer which secure Rail Assembly.
Pull out Locking Tube Assembly and
take apart Rail Assembly, as shown in
figure 9.
8.
Release M5x15mm Phillips Head
Screw which secure aluminum rail to
take the rail apart, if necessary, as
shown in figure 10.
9.
Use Phillips head screw driver to
release two M6x10m/m Phillips head
screws and two 1/4" x 19 x 1.5T flat
washers, if replacing Slide Wheels is
necessary, as shown in figure 11.
10.
Reverse above steps to resume parts.
