Model
SE578A
Service
Replacing Parts
Parts
3. Connecting Arm Assembly
Rev.
1
2
3
4
Procedures：
1.
Follow the procedures to disassemble
Swing Arms (if only to take apart
Connecting Arm, then only releasing
Rod End Bearing is necessary.)
2.
Use 12mm wrench to release
5/16
"
x15mm Hex Head Bolt together
with 5/16
"
x23 Flat Washer, which
secure the Connecting Arm, then pull
out Carriage Bolt under the Pedal, as
shown in figures 1, 2.
3.
To disassemble Adjustable Pedal, use
14mm wrench to release 3/8
"
x19 Hex
Head Bolt, 3/8
"
x19x1.5T Flat Washer
and 3/8
"
x7T Nyloc Nut, as shown in
figure 3. Then use Phillips head screw
driver to release M5x10mm Phillips
Head Screws and ψ19
×
ψ14
×
ψ10
×
(5+4)T_ Bushing, as shown in
figures 4, 5 and pull out Axle Of
Locking Pin. Use C-ring pliers to
release ψ10 C-ring and pull out
Locking Pin, as shown in figures 6, 7.
