A01-00159 Rev B
13
Step 2: UPS output connection
There two kinds of outputs: programmable outlets and general outlets.
Please connect non-critical devices to the programmable outlets and
critical devices to the general outlets. During power failure, you may
extend the backup time to critical devices by setting shorter backup
time for non-critical devices.
Step 3: Communication connection
Communication port:
USB port
RS-232 port
Intelligent slot
To allow for unattended UPS shutdown/start-up and status monitoring,
connect the communication cable one end to the USB/RS-232 port and
the other to the communication port of your PC. With the monitoring
software installed, you can schedule UPS shutdown/start-up and
monitor UPS status through PC.
The UPS is equipped with intelligent slot perfect for either SNMP card.
When installing either SNMP card in the UPS, it will provide advanced
communication and monitoring options.
Step 4: Network connection
Network/Fax/Phone surge port
Connect a single modem/phone/fax line into surge-protected “IN”
outlet on the back panel of the UPS unit. Connect from “OUT” outlet to
the equipment with another modem/fax/phone line cable.
