Appendix D: SMASH Command Line Utility
49
Using advanced options:
(A)ll option
The –a(ll) option shows all properties of the targets.
(L)evel option
The level option shows the properties of targets down to the level “n” specified in the
command.
Æ
show –l 3 /system1
This command will show the properties of the targets up to the third level starting from
the CDT or the target in the command line.
(E)xamine option
The examine option is used to check the correctness of the command. This option will not
execute the command but only say if the command given is ok or not.
Æ
cd –examine /system1
Display option
The display option is used to display the properties of targets. If display is associated with
“all” then it shows all the properties of the target.
Format option
The format option specifies the output format of the commands. The formats are plain
text (default), clpxml, clpcsv, clpkeyword.
Æ
show –format=clpxml –display targets.
Wildcard option
Instead of UFsT one can use “*” to indicate all targets. Suppose under a CDT we have
sensor1 to sensor10. To see the value of all the sensors we can just use sensor*. It will
enlist all the sensor data.
Æ
show –display properties= IP /nic*
Summary of Contents for MegaRAC G4
