American Megatrends 28 series, User Manual

Page: 101 / 126

AMI EZ-Flex Base Board User's Guide
95
Message Explanation
The hard disk drive utility waited beyond a
preset specified time limit.
Drive Parameter Activity
Failed A reset command was sent to the controller
followed by drive parameters. Using these
parameters, the controller did not get a
response from the hard disk. Make sure the
drive type is correct.
ECC Corrected Data Error The ECC value (explained above) read from
the disk is not the same value which was
written to the disk. The data is not correct. An
attempt was made to correct the data, but the
ECC value is not corrected.
Requested Sector Not
Found The requested sector could not be found.
Reset Failed The reset command did not properly reset the
hard disk.
Seek Operation Failed A seek command failed. A seek operation is
the act of finding a particular sector on the
hard disk.
Undefined Error -
Command Aborted An unidentifiable error condition occurred.
Write Fault on Selected
Drive A write fault occurred during the write
operation on the hard disk drive.