CAUTION
Risk of crushing when adjusting the
drawbar
When lifting and lowering the drawbar,
never reach between the hydraulic
cylinder and the hole pattern mount.
6.
Pull out the pin
1
.
7.
Lift or lower the drawbar to the required height.
8.
Fix the position of the hydraulic cylinder with the
pin in the hole pattern
2
.
1
2
CMS-I-00004325
9.
Slide the safety clip
1
onto the pin.
10. Secure the pin with a linch pin
2
.
11. Remove the crane or lifting gear.
1
2
CMS-I-00004323
12. Check the slope of the drawbar eye.
The drawbar eye must be set with an upwards
slope of 0° - 10°.
13.
If the slope of the drawbar eye needs to be
adjusted, then
loosen the bolt
1
.
14. Unscrew the bolt
2
.
15. Set the drawbar eye to the required slope using
the hole pattern
3
and fix with the bolt
2
.
0 - 10°
4
CMS-I-00004327
6 | Preparing the machine
Preparing the drawbar
MG6212-EN-II | C.1 | 12.04.2021
59
