16.
If the required slope cannot be achieved,
the drawbar eye can be installed rotated by 180°.
The holes
4
are then facing down.
17. Tighten the bolts with 210 Nm.
6.4.2 Adjusting the lower drawbar
1.
Park the tractor and the implement on a level
surface.
2.
On the tractor, measure the distance
A
from the
centre of the straight drawbar to the ground.
CMS-I-00003328
3.
Measure the length of the drawbar when the
hydraulic cylinder
1
is half extended.
When the hydraulic cylinder is half extended, the
distance
B
is about 430 mm.
CMS-I-00004108
4.
Measure distance
A
for the drawbar. Compare
the distance with the distance on the tractor.
5.
If the height of the drawbar needs to be
adjusted, then
loosen the bolt
1
.
6.
Unscrew the bolt
2
.
7.
Using the holes
3
, adjust the drawbar eye to the
measured distance
A
from the tractor, with an
upwards slope of 0 - 10°.
2
1
3
A
0 - 10°
CMS-I-00003699
CMS-T-00005184-A.1
6 | Preparing the machine
Preparing the drawbar
MG6212-EN-II | C.1 | 12.04.2021
60