6.
Open the drawbar hydraulic valve
1
.
7.
Open the cutting deck hydraulic valve
2
.
8.
Lower the front implement with the cutting deck
until the cage roller is resting on the wooden
board
1
2
CMS-I-00003367
9.
Check whether the lower edge
1
of the cutting
deck is aligned parallel to the ground.
10. If necessary, lift the implement with the cutting
deck and adjust the height of the cage roller using
the crank
2
.
11. Lower the front implement with the cutting deck
again onto the wooden board.
12. Check the parallel alignment of the cutting deck
again.
13. Adjust the height of the support wheels
3
like
for the cutting height adjustment, see page 85.
=
=
1
2
3
CMS-I-00004255
14. Close the cutting deck hydraulic valve
1
.
The cutting deck is fixed in the setting. Only the
support wheels now guide the cutting deck.
1
CMS-I-00004251
6.10 Preparing the machine for road travel
1.
Switch off the PTO shaft drive on the tractor.
2.
Completely empty the grass collector.
3.
Remove loose clippings on the cutting deck.
CMS-T-00004722-A.1
6 | Preparing the machine
Preparing the machine for road travel
MG6212-EN-II | C.1 | 12.04.2021
96
