Using the machine
7
7.1 Using the implement
1.
Align the implement parallel to the ground.
2.
Switch on the fan.
3.
Lower the implement to the working height
or
when working with the T-Pack F,
Lower the implement onto the T-Pack F.
4.
Block the hydraulic system of the 3-point power
lift at the working height
or
when working with the T-Pack F,
Move the hydraulic system of the 3-point power
lift into float position.
5.
When beginning with half the implement width,
see "Operating the one-sided switching".
6.
Drive off with the tractor.
NOTE
The control computer monitors the fan speed.
If the actual speed deviates from the nominal
speed by more than 10 %, an acoustic signal
is issued and a warning is displayed. It is
possible to set the percent deviation.
The control computer monitors the metering
roller speed. If the actual speed deviates from
the nominal speed by more than 10 %, an
acoustic signal is issued and a warning is
displayed. It is possible to set the percent
deviation.
CMS-T-00003112-B.1
CMS-T-00003116-B.1
7 | Using the machine
MG6492-EN-II | G.1 | 26.04.2021
88
