10
Machine Setup
5. Pull the draw latch forward to release the access door to gain entry to the sanding chamber. (See Figure 12)
6. Rotate the release lever forward. (See Figure 11)
CAUTION: Damage to the sanding drum will occur if the machine is operated without a sanding belt.
Figure 11
Figure 9
Figure 10
7. Install a new abrasive belt by sliding the abrasive over the tension roller and contact wheel. (See Figure 12)
8. Rotate the release lever backward to tighten the abrasive belt.
CAUTION: Do not force the release lever. Doing so can damage the tracking mechanism and cause the abrasive belt to mis-track.
9. Depending on the model, the control switch is found on either the operating handle or on the motor. Verify that the control switch is set to
“OFF”. See the marking on the switch.
10. Connect the electrical cord. On certain models, the connection must be twisted clockwise to lock.
11. Jog (turn on momentarily - test operation) the control switch while observing the belt tracking. Follow the procedures outlined in the “Sander
Adjustment Procedures” on page 16 to correct the belt tracking. There is also a label on the inside of the access door that outlines the
belt adjustment.
12. Close the access door. Place the end of the draw latch over the keeper on the access door and push the draw latch flat against the
mainframe to secure.
Figure 12
EN
Summary of Contents for 07104
