Amano 07104, Operator'S Manual

Page: 15 / 72

2. Drive the adjusting screw in, to sand heavier on the left (the drive belt
side). Back the adjusting screw out, to sand heavier on the right (the
side opposite the drive belts). Test the setting on an even surface.
Make further adjustments if necessary.
3. Mark new pointer location on main frame.
Belt Tracking
NOTE: The sanding belt should run evenly on the face of the drum. For
this, the outer edge of the sanding belt must be .09 inches (2mm) out from
the end of the drum. This provides optimum transition between “passes”.
WARNING: Injury to the operator could occur if any
machine adjustments are made while the
motor is running. Do not attempt to make any
adjustments while the machine is plugged in or
running.
To adjust the belt tracking follow this procedure:
1. Locate the belt tracking adjuster screw. (See Figure 18A)
2. Hold the belt tracking adjuster screw and loosen the locknut.
(See Figure 18B).
3. Rotate the tracking adjuster screw counterclockwise to move the belt
in.
4. Rotate the tracking adjuster screw clockwise to move the belt out.
5. Test adjustment and tighten the locknut.
Operating Control
To increase the travel or extend the reach on the grip control, follow this
procedure:
1. Loosen the locknut on the control rod. (See Figure 19A)
2. Screw the control rod adjuster (See Figure 19B) “In” until the desired
reach is found.
3. Tighten the locknut.
To decrease the travel or reduce the reach on the grip control, follow this
procedure:
1. Loosen the locknut on the control rod. (See figure 20A)
2. Screw the control rod
adjuster “out”
until desired reach is found.
3. Tighten the locknut.
15
Figure 19
Figure 18
A A
A B
A A
A B
EN
Figure 20
A