Altuscn KN2116a, User Manual, Page: 38 / 306

KVM Over the NET™ User Manual
22
3. Plug the connectors on the KVM Adapter Cable into the appropriate ports
of the server you are installing. (See Adapter Cable Connection Diagram ,
page 25.)
4. Plug a cable from the LAN or WAN into the KVM Over the NET™
switch’s primary network interface socket.
5. (Optional) Plug another cable from the LAN or WAN into the KVM Over
the NET™ switch’s backup (secondary) network interface socket.
6. (Optional) Use Cat 5e cable to connect the KVM Over the NET™ switch’s
PON port to an SA0142 Adapter. Connect the Adapter to the PON IN port
of a Power Over the Net™ unit.
Note: The PON unit shown in the example is the PN0108. See Supported
Power Over the Net™ Units , page 281, for a list of suitable units.
7. (Optional) Use Cat 5e cable to connect the KVM Over the NET™ switch’s
Modem port to an SA0142 Adapter. Connect the Adapter’s serial
connector to the modem’s DB-9 port.
8. Ground the switch using proper grounding wire to connect the switch’s
grounding terminal to a suitable grounded object.
Note: Do not omit this step. Proper grounding helps to prevent damage to
the unit from surges or static electricity.
9. Plug the power cord(s) supplied with your package into the switch’s power
socket, and then into an AC power source.
For the KN2124v, KN2140v, KN4124v and KN4140v, when using a
single power socket, be sure to turn on the correct power switch (see
Power Switch , page 13). When using both power sockets, either of the
power switches can be used to turn on the KVM switch. To enable dual
power, turn on both power switches.
Note: If you are connecting the power to a UPS or an ALTUSEN PN9108/
PN0108, be sure to use the utility power cords supplied with your
package instead of standard power cords.
After the KVM Over the NET™ switch is cabled up you can turn on the power.
After it is powered up, you can turn on the servers.