Alpina 274100320/A17, Operator'S Manual

Page: 158 / 510

EN - 16
5. Excessive noise and/or
vibration is experienced
whilst working
Loose or damaged parts Turn off the machine
remove the battery and:
– inspect for damage;
– check for and tighten
any loose parts;
– have any damaged parts
replaced or repaired with
parts having equivalent
specifications.
6. Battery power reserve is low Severe working conditions
requiring greater
current absorption
Optimise operations
(par. 7.2.1)
Battery is insufficient for
operating requirements
Use a second battery or an
extended battery (par. 7.2.1)
Decrease in battery capacity Purchase a new battery
7. The battery charger is
not recharging the battery
Battery is not correctly inserted
in the battery charger
Check it is correctly
inserted (par. 7.2.2)
Unsuitable environmental
conditions
Recharge the battery in places
with suitable temperatures
(see battery/battery charger
instruction manual)
Dirty contacts Clean the contacts
The battery charger
is not energised
Check it is plugged in and the
power socket is energised
Faulty battery charger Replace with an
original spare part
If the problem persists,
refer to the battery/
battery charger manual
If problems persist after having performed the above operations, contact your dealer.
16. ATTACHMENTS ON REQUEST
16.1 BATTERIES
Different capacity batteries are available to
suit specific operating requirement s (Fig. 28).
The list of approved batteries for this machine
is found in the "Technical Data" table.
16.2 BATTERY CHARGER
Device used to recharge the battery (Fig. 29).