Allied Telesis AT-MCF2000, Installation Manual

Page: 143 / 190

Section II: Installation 143
Chapter 22
Starting a Local Management Session
To start a local management session on the optional AT-MCF2000M
Management Module:
Note
The initial management of the AT-MCF2000M Management Module
has to be from a local management session.
1. Connect the DIN-8 connector on the RS-232 Serial Management cable
included with the AT-MCF2000M Management Module to the RS-232
Terminal port on the management module.
Figure 82. Connecting the RS-232 Serial Management Cable to the RS-
232 Terminal Port
2. Connect the DB-9 connector on the management cable to an RS-232
port on a terminal or a PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
❒
Baud rate: 115200 bps (The baud rate of the RS-232 Terminal port
is adjustable from 9600 to 115200 bps. The default is 115200 bps.
To adjust the baud rate, refer to the
AT-S85 and AT-S97
Management Software Command Line User’s Guide .)
❒
Data bits: 8
❒
Parity: None
120 3 a
AT-MCF
2000
M
S TACK
MANAG
EMENT
TERMIN
AL
10/100
/1000
BA
S E-T
R
S -2 3
2
RE
S
ET
S D
RDY
BU S
Y
MA
S TER
POWER
BOO
T
RDY
FAULT
1000 L
INK
ACT
10/10
0 LINK
ACT
FDX
HDX
COL
LINK
ACT
PORT A
CTIV
ITY AT-MCF2KF
AN
NORMAL
FAULT
S
TAT
U
S