58
801805
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
41. WASHER BELT
a. Go to rear of machine and remove two screws
holding rear panel to side panels of control
cabinet. Refer to Figure 7.
b. Reach in through opening and remove screw
holding service door to control shield and
remove service door. Refer to Figure 11.
c. Remove screws holding lower rear access panel
to rear panel and remove access panel. Refer to
Figure 11.
d. Run belt off pulley while slowly turning pulley.
e. Remove belt from motor shaft.
NOTE: When installing belt, adjust belt tension per
Refer to Paragraph 82.
Figure 11
SWD1670S
Pulley
Belt
Access
from Above
Rear
Access
Panel
Motor
Belt
Access
from Below
