16
53277
Section 4 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
9. PUSH-TO-START SWITCH
Refer to Figure 7
a. Remove control panel. Refer to Paragraph 7.
NOTE: Refer to appropriate wiring diagram when
rewiring accumulator.
10. TEMPERATURE SELECTOR SWITCH
Refer to Figure 7
a. Remove control panel. Refer to Paragraph 7.
NOTE: Refer to appropriate wiring diagram when
rewiring accumulator.
To Test Push-To-Start Switch
1. Remove two control panel attaching screws and
lift assembly off cabinet top.
2. Disconnect all wires from switch.
3. Set Volt-Ohm meter on Ohms scale and
calibrate at appropriate scale.
4. Unplug dryer from electrical supply and
disconnect wires from switch terminals.
5. Place meter probes on switch terminals. You
should see an “infinite” reading on the meter.
6. With probes attached to switch, press the start
switch button. You should read “0” (zero)
Ohms.
To Test Fabric Switch:
1. Disconnect wires from switch.
NOTE: Refer to appropriate wiring diagram
when rewiring switch.
2. Set meter to read Ohms and apply meter leads to
terminals:
3. Meter should give “no reading” from L1 to C or
from L2 to C in DeLICATE or FLUFF.
4. Meter should give “no reading” from C to 1 in
DELICATE.
L1 and C
“zero” reading in NOMAL
L1 and 2
2 and C
L2 and C
“zero” reading in
PERMANENT PRESS
2 and C
L1 and 2
“zero” reading in DELICATE
2 and 1
