Publication 6186M-UM001D-EN-P
A-2
Touchscreen Serial Interface
Enabling the Touchscreen Interface
The VersaView 6186-M Industrial Flat Panel Monitor provide a female
DB-9 connector on the side of the panel. This connector provides the
serial interface for the touch controller.
Interconnecting wiring to the host serial port connection is shown in
the following table.
Installing the Touchscreen Driver Software
To install the touchscreen driver software correctly, obtain the
following information about the host hardware:
•
The COM port in use for the touchscreen. Ensure that the RS-232
cable is properly installed between the monitor port and the
host’s COM port.
•
The baud rate at which the controller is operating. You will need
to match the baud rate at the COM port. The controller baud rate
is factory set at 9600.
Once you have obtained this information, install the software using
the installation disks found in the touchscreen accessory package.
Performing a Calibration
After installing the driver software, follow the instructions in the
touchscreen documentation.
Following installation of the touchscreen software and calibration, the
touchscreen is ready to use.
Touchscreen Interface
Monitor
(DCE Device)
DB-9 (Female)
Signal Description
Host (DTE Device)
DB-9 (Male)
DB-25 (Male)
1
Not connected (DCD)
1
8
2
Transmit Data (TXD)
2
3
3
Receive Data (RXD)
3
2
4
Data Terminal Ready (DTR)
4
20
5
Common Signal Return (SG)
5
7
6
Not Connected (DSR)
6
6
7
Request to Send (RTS)
7
4
8
Clear to Send (CTS)
8
5
9
Not Connected
9
22
Summary of Contents for VersaView 1200M
