Allen-Bradley VersaView 1200M, User Manual

Page: 18 / 62

Publication 6186M-UM001D-EN-P
2-8 Installation
Panel Mounting Guidelines
Observe the following precautions when installing the unit in a panel:
•
Confirm that there is adequate space behind the panel.
– Allow at least 26 mm (1.0 in.) on the sides and bottom and
51 mm (2.0 in.) on the top for ventilation.
– A cabinet with a minimum depth of 74 mm (2.9 in.) is
sufficient.
•
Take precautions so that metal cuttings do not enter any
components that are already installed in the panel.
•
Supporting panels should be at least 14 gauge to ensure proper
sealing against water and dust, and to provide proper support.
The mounting hardware supplied accommodates panels up to
6.25 mm (0.25 in.) thick.
Installing Panel Mount Monitor
1. Prepare panel cutout for monitor. Refer to cutout drawings on
page 2-4.
2. If access to the rear of the monitor is not available following
installation, attach the cables to the monitor at this time. Refer
to Monitor Connections on page 2-15 for complete details.
3. Make sure the monitor’s sealing gasket is properly positioned on
the monitor. This gasket forms a compression type seal. Do not
use sealing compounds.
4. Place the monitor in the panel cutout.
IMPORTANT
Supporting panels must be cut to specifications
before installation.
ATTENTION
Failure to follow these warnings may result in
personal injury or damage to the panel components.