Allen-Bradley VersaView 1200M, User Manual

Page: 11 / 62

1 Publication 6186M-UM001D-EN-P
Chapter
2
Installation
Before Unpacking the
Monitor
Before unpacking your new monitor, inspect the shipping carton for
damage. If damage is visible, immediately contact the shipper and
request assistance. Otherwise, proceed with unpacking.
Hazardous Locations
This equipment is suitable for:
•
Class I, Division 2 Groups A, B, C, D
•
Class II, Division 2 Groups F, G
•
Class III, Division 1
•
or non-hazardous locations
The following statement applies to use in hazardous locations.
The VersaView Flat Panel Monitors and AC adapter have an operating
temperature code of T4 (maximum operating temperature of 55°C or
131°F). Do not install the terminals in environments where
atmospheric gases have ignition temperature less than 55°C or 131°F.
TIP
Make sure you keep all the original packaging for
the monitor in case you need to return the monitor
for repair. Both the inner and outer packing cartons
should be used to ensure adequate protection for
any units returned for service.
WARNING
Explosion Hazard
•
Substitution of components may impair
suitability for hazardous locations.
•
Do not disconnect equipment unless power has
been switched off and area is known to be
non-hazardous.
•
Do not connect or disconnect components
unless power has been switched off.
•
All wiring must comply with N.E.C articles
501-4(b), 502-4(b), 503-3(b) as appropriate.
•
Peripheral equipment must be suitable for the
location it is used in.
Allen-Bradley Spares