Publication 1734-UM003A-EN-P - August 2000
2-4
Installing the Very High Speed Counter Module
Installing the Removable Terminal
Block
A removable terminal block is supplied with your mounting base
assembly. To remove, pull up on the RTB handle. This allows the base
to be removed and replaced as necessary without removing any of the
wiring. To reinsert the removable terminal block, proceed as follows.
1.
Insert the RTB end opposite the handle into the base unit. This
end has a curved section that engages with the mounting base.
2.
Rotate the terminal block into the mounting base until it locks
itself in place.
3.
If an I/O module is installed, snap the RTB handle into place on
the module.
Removing a Mounting Base
To remove a mounting base, you must remove any installed module,
and remove the removable terminal block (if wired).
1.
Unlatch the RTB handle on the I/O module.
2.
Pull on the RTB handle to remove the removable terminal block.
3.
Press in on the module lock on the top of the module and pull
up on the
I/O module to remove from the base.
4.
Remove the module to the right of the base you are removing.
(The interlocking portion of the base sits under the adjacent
module.)
5.
Use a small bladed screwdriver to rotate the orange DIN rail
locking screw on the mounting base to a vertical position. This
releases the locking mechanism.
6.
Then lift the mounting base straight up to remove.
Hook the RTB end into
the mounting base end,
and rotate until it locks
into place.
Summary of Contents for POINT I/O 1734-VHSC24
Page 1: ...Very High Speed Counter Module Cat No 1734 VHSC5 and VHSC24 User Manual ...
Page 22: ...Publication 1734 UM003A EN P August 2000 1 14 About the Very High Speed Counter Modules ...
Page 48: ...Publication 1734 UM003A EN P August 2000 4 8 Configuring Your Very High Speed Counter Module ...
Page 63: ......