1
1
7
7
5
5
6
6
-
-
Q
Q
S
S
1
1
0
0
4
4
A
A
-
-
E
E
N
N
-
-
P
P
C
C
o
o
n
n
t
t
r
r
o
o
l
l
L
L
o
o
g
g
i
i
x
x
Q
Q
u
u
i
i
c
c
k
k
S
S
t
t
a
a
r
r
t
t
Page 68
8. When the next Module Properties screen appears, modify the parameters for Channel 0 as shown
below.
FYI
The Channel Configuration Screen shown above allows you to configure the output state
on a per channel basis. To configure a channel, click on the channel button for the
channel you want to configure.
Program Mode/Fault Mode
§
Hold Last State
- Click on this button (under Output State in Program Mode or Fault
Mode) if you want the output channel to remain at the last output value, OR
§
User Defined Value
- Click on this button (under Output State in Program Mode or
Fault Mode) if you want the output channel to go to a specific value when the owner
controller is switched into program mode. If you click on this button, you should
enter a value in the box to the right:
By checking the Ramp to User Defined Value box, you can choose to ramp to the user-
defined value rather than proceed to the value as fast as possible. You select the Ramp
Rate on the next configuration screen.
9. Click on
Next
.
