Allen-Bradley 2080-LC20-20AWB, User Manual

Page: 28 / 212

18
Rockwell Automation Publication 2080-UM005E-EN-E - March 2018
Chapter 2 About Your Controller
For this example, the new IP Address is set to the following:
•
IP address = 192.168.1.10
•
Subnet mask = 255.255.255.0
•
Gateway address = 192.168.1.1
RMCC EtherNet/IP Example – Set the Message Length
After the new IP address is configured and applied, the controller will disconnect
from Connected Components Workbench if communication is through
Ethernet.
You can verify that the IP address has changed after performing RMCC by
looking at the Ethernet settings for the controller.
RMCC EtherNet/IP Example – Verify Address Change
Agency Certifications
•
UL Listed Industrial Control Equipment, certified for US and Canada.
UL Listed for Class I, Division 2 Group A,B,C,D Hazardous Locations,
certified for U.S. and Canada.
•
CE marked for all applicable directives
• C-Tick marked for all applicable acts
•
KC - Korean Registration of Broadcasting and Communications
Equipment, compliant with: Article 58-2 of Radio Waves Act, Clause 3.
IMPORTANT
You should not perform IP address changes continuously. Allow an
interval of at least six seconds before performing the next IP address
change in order for duplicate address detection to work properly.