Allen-Bradley 1756-L63XT, User Manual

Page: 68 / 212

68 Rockwell Automation Publication 1756-UM001O-EN-P - October 2014
Chapter 3 Start Using the Controller
After clicking Store, the project is saved to the memory card as indicated
by the controller status indicators.
Load from the Memory Card
After you have set the communication path, are online with the controller, and
have changed the controller to Program mode, complete these steps to load a
project to the controller from the memory card.
1. Open the Controller Properties and click the Nonvolatile Memory tab.
2. Click Load/Store.
With these controllers These indications show the store status
1756-L6 x While the store is in progress , the following occurs:
• OK indicator on the controller is solid red
• A dialog box in the Logix Designer application indicates that the store is in
progress
When the store is complete , the following occurs:
• OK indicator on the controller is momentarily red, then solid green
1756-L7 x While the store is in progress , the following occurs:
• OK indicator is flashing green
• SD indicator is flashing green
• SAVE is shown on the status display
• A dialog box in the Logix Designer application indicates that the store is in
progress
When the store is complete , the following occurs:
• OK indicator on the controller is momentarily red, then solid green
• SD indicator on the controller is Off
IMPORTANT
Allow the store to complete without interruption. If you interrupt the
store, data corruption or loss can occur.
TIP
If Load/Store is dimmed (unavailable), verify the following:
• You have specified the correct communication path and are online with the
controller.
• The memory card is installed.
If the memory card is not installed, a message in the lower-left corner of the
Nonvolatile Memory tab indicates the missing card as shown here.