Alamo RX96, Operator'S Manual, Page: 141 / 172

OPERATION
RX96 03/09 Operation Section 4-45
© 2009 Alamo Group Inc.
OPERA
T
ION
15. TROUBLESHOOTING GUIDE
Problem Possible Cause Remedy
MOWER VIBRATES Blade locked back. Loosen locked Blade.
Drivelines not phased. Replace Driveline.
Blade broken. Replace Blades in sets.
Blade Carrier bent. Repair or replace Carrier.
Blade Hub not properly Remove Hub, check for wear
seated on Shaft. and replace or seat properly.
New Blade matched with Replace Blades in sets.
worn Blade.
Not Cutting Clean Blades dull. Sharpen or replace Blades.
Blade rotation incorrect. Use correct Blade for Carrier.
Using Straight Blades. Use Fan Blades in grass.
Carrier RPM too low. Increase PTO speed.
Mower not level. Adjust machine level (in very
heavy weeds, 1/2" to 1" low in front).
Tractor tires mashing down grass. Increase tire spread to 90”
Ground speed too fast. Reduce ground speed.
Blades locked back. Free blades.
Blades riding up due to blade bolt Replace blade bolts.
wear.
Blades bent up.
Replace Blades.
Blades Wear Fast Cutting in sandy or rocky conditions Increase cutting height.
Blades too soft. Replace Blades; with hardened,
high-quality, Alamo Industrial Blade
from the manufacturer.
Blade Bolts Working Loose Bolts not tightened. Tighten Bolts to 300 ft./lbs.
Bolt hole elongated or oversized. Replace Blade Carrier.
Locknut worn out. Replace Locknut.
Gearbox Noisy Improper Backlash. See your local Alamo Industrial Dealer.
Rough gears. Run in or change Gears.
Worn Bearing. Replace Bearing.