
OPERATION
RX96 03/09
Operation Section 4-5
© 2009 Alamo Group Inc.
OPERA
T
ION
3. TRACTOR REQUIREMENTS
The tractor used to operate the mower must have the power capacity to lift, pull, and operate the Power Take
Off (PTO) at the mower’s rated speed while traveling at a ground speed between 2 and 5 MPH. Operating the
mower with a tractor that does not meet the following requirements may cause tractor or mower damage and
be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
•
ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
•
Tractor Safety Devices ..................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
•
Tractor Horsepower:
-Minimum .................. Lift-55 HP, Pull & Semi-Mount-30 HP
-Maximum .................. 90 HP
•
Tongue Weight ................................. 960 lbs.
•
Hitch -Lift Type Mower:
- Lifting Capacity ........ 2000 lbs.
- 3-Point Hitch ............ Cat II-III
-Semi-Mount
-3 Point Hitch ............. CAT II/III
-Pull Type Mower
-Drawbar .................... 14” extension for 540 RPM unit and 16” for 1000 RPM unit,
safety chain attachment point
-Hydraulics................. Optional
•
Front End Weight ............................. As needed to maintain 20% weight on front axle
•
Power Take Off ................................. 540 RPM 6-spline or 1000 RPM 21-spline, 1-3/8” diameter output
shaft.
3.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer.
OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.
(SG-7)
Summary of Contents for RX96
