AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page
21
of
52
4. SET LAMINATION FILM/MANUAL MODE (cont’d)
13. Turn on the power switch. The heat rollers should
begin to get hot. If they do not, check that the RFID
chip is in place on the lower film roll and facing the
non-operator side of the machine.
14. Push the Manual MOVE Switch towards the exit
of the machine. The threading card and film should
start to move. If they do not move DO NOT LOWER
THE LAMINATION HANDLE. Carefully push the trailing
edge of the threading card firmly at the lamination
roller area to make the leading edge of the card
engage the rollers near the exit. In one or two
seconds the threading card, along with two sheets of
film should exit the discharge.
If the card and film to do not exit the machine within 5 seconds
STOP!
Film could be
accumulating within the machine. If this is allowed to continue damage to the machine will
occur!
