AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page
12
of
52
2. NAMES AND FUNCTION
2-4. LCD DISPLAY
WARM UP
Indicates the machine is being heated up.
Operation is not possible during this time.
LCD may indicate “READY” when no RFID tag is available (see
information on film roll RFID tag elsewhere in this manual).
1)
Indicates the set temperature in Fahrenheit.
When the ALM3222 reaches set temperature and regulation begins the buzzer beeps three times.
“READY” appears:
•
If machine is fully heated.
•
Under certain conditions if the RFID tag is not in place and machine is not heated.
If the machine has been properly threaded it is ready to be run in automatic mode. If
the machine has
not
been threaded, or if you are unsure that it has been, the START button
should NOT be pressed. To set the film and thread the machine see chapter 4 starting on page
16.
1) [TEMP] indicates the set temperature in Fahrenheit. See chapter 5-2-1 on page 27.
2) [SPEED] indicates the set speed in inches per minute. See chapter 5-2-2 on page 28.
3) [MARGIN] indicates that the trimming and cutting is with or without margin of film on the front and
back (leading and trailing edges) of the laminated paper. NOTE: A “margin” is a (sealed) edge of film
around the laminated paper. See chapter 5-2-5 on page 33.
4) [FINE MODE] indicates the status of Fine Mode. See chapter 5-2-7 on page 35.
5) [SET COUNT] indicates number of the papers to be processed. See chapter 5-2-5 on page 33.
