AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page
35
of
52
5. AUTOMATIC OPERATION (cont’d)
5-2-6. CUT ADJUST
This function adjusts the cutting positions at both the leading, and trailing edges of the paper.
NOTE:
These settings are retained in memory after a power outage.
NOTE:
These settings only affect the leading and trailing edge cuts. They do not affect the side cuts
made by the Trimmer Unit.
NOTE:
It is recommended to read and record the present values shown on the display before adjusting.
It may be helpful if it is necessary to set back to a past value.
NOTE:
Each ALM3222 has its own Cut Adjust values. The numbers seen are relative only to this
particular machine and not to anything in the “real world”.
1. Select Cut Adjustment from the Mode
display.
2. Press TEMP/SPEED button and move the cursor to F or B.
F: cutting position at the front end (leading edge)
B: cutting position at the back end (trailing edge)
3. Set value using the UP/Down buttons. Adjustment can be done between
- 0.40" and + 0.40".
HINT:
The
more positive
the number the more margin of film around the paper will remain.
The
more negative
the number the close to the paper the cutting will occur (with the possibility of
cutting into the paper itself).
