AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page
19
of
52
4. SET LAMINATION FILM/MANUAL MODE (cont’d)
8. Raise the Lamination Handle to the OPEN
position to separate the heat and pull rollers for
threading.
9. Pull the upper film off the roll. Pull it down and
over the upper rotating idler bar
. Bring the end of
the film down until it just touches the lower film.
This should overlap both heat rollers by a few
inches.
10. Bring the lower sheet of film up and over the
upper sheet of film. There should now be two
sheets of film crossing the heat rollers and
overlapping each other by about 6-8”
