5-35/64
REF
8-21/32 REF
4-23/32 REF
3-3/16
REF
8.031
3.228
.748 REF
.315 REF
1
06
08
08
1
04
1
M6 x 1.0 BRASS INSERT
MOLDED FLUSH TO
BOTTOM SURFACE (TYP) 4
NOTE:
ENCLOSURE MAY BE MOUNTED FROM THE TOP
WITH A #8 OR M4 SCREW THRU THE ENCLOSURE
OR FROM THE BOTTOM WITH A M6x1.0 SCREW.
Ø.177 HOLE
(TYP) 4
2.3 ATTACHING TO VEHICLE
2.3.1 Universal II
If the Universal II is to be mounted in a well, be certain that adequate drainage is provided. While the unit has been designed to
withstand adverse environmental conditions, it cannot be submerged.
The Universal II has two options for mounting:
1. Through hole mounting. The through hole mounting holes provided on the Universal II are .177 inches in di
ameter and suitable for #8 or M4 screws. These allow inserting screws from the top side and into threaded
holes on the customer’s back panel.
2. Mounting with threaded inserts. There are four threaded inserts in the enclosure bottom which are M6 X 1.0.
These allow screws to be inserted from behind the customer’s back panel and into these inserts on the Uni
versal II enclosure bottom.
Mounting hole locations for methods 1 and 2 above are shown in Figure 2-1. Please note that it is important that the mounting
surface be flat. Sufficient room should also be allowed in mounting location to insure cabling does not have sharp bends close to
the connectors.
DO NOT OVERTIGHTEN SCREWS AS INSERTS COULD BE DAMAGED OR ENCLOSURE
Figure 2-1 Universal II Mounting Hole Locations
9
