OG-X-FR openGear Frame v1.0r1 29 www.aja.com
• Specify the card(s) to upload the file to by selecting the check box(es) for
the cards you wish to upload the file to.
• Verify that the card(s) you wish to upload the file to. The Error/Warning fields
indicate any errors, such as incompatible software or card type mismatch.
• Click Finish to display the Uploading to Selected Devices dialog.
8. Monitor the upgrade.
• The Uploading to Selected Devices dialog enables you to monitor the
upgrade process.
• Notice that each card is listed in the dialog with a button. This button is
replaced with a Reboot button once the software file is loaded to that card.
IMPORTANT: Avoid clicking the individual Reboot buttons until all cards have successfully
completed the file upload process and the OK button, located in the bottom right
corner of the dialog, is enabled.
• Click OK to reboot all the cards listed in the Uploading to Selected Devices
dialog.
• The Reboot Confirm dialog displays, indicating the number of cards that will
reboot. Click Yes to continue the upgrade process. Note that clicking Cancel
or No returns you to the Uploading to Selected Devices dialog without
rebooting the card(s).
NOTE: The communications processor of the Network Controller Card requires
approximately 30 seconds to re-start and re-establish network communications.
• The card(s) are temporarily taken offline during the reboot process. The
process is complete once the status indicators for the Card State and
Connection return to their previous status.
Troubleshooting
If you encounter problems when upgrading your card software, verify the
following:
• Your network settings on the card are valid.
• The Ethernet cable is properly connected if you are uploading the file via a
network connection.
• The file you are attempting to load is a *.bin file that is for the card you are
upgrading.
Card-edge Controls for the MFC-8322-S
Refer to Figure 3.1 for the location of card control features such as the Alarm Mute
button, and the Alarm Config jumpers.
NOTE: The MFC-8322-S provides a single DashBoard connection.
Figure 8. MFC-8322-S Card Controls
