Users Guide
Page
18
of
127
Printed for Reference Only on November 15, 2006
2-1 How to setup Tour
1). Click program cell for you want tour number and type in preset position numbers in the order.
2). Click “Save” button.
e.g. 23,44,12,25,16,5,38 : 23
à
44
à
12
à
25
à
16
à
5
à
38
à
23
à
44
à
12…
2-2. How to do Touring
Just click the button of “ Run” then, the PTZ camera will start “touring”. If click the button again, PTZ camera
will stop “touring”.
3. Control & Setup
-
Diff. Operation Mode : If you tick the box, the keys of U, D, L, R will be changed from “camera move
key” to “cursor move key”. (In case of CyberScan1, you must tick the box to insert ‘START(PTZ)’ value
and ‘END(PTZ)’ value in the setting of ‘AUTO SCAN SETUP’. You also need to tick the box when you
input title for the position of the Auto scan (Touring). Please refer to the manual of PTZ camera for the
details.
-
MENU : Appear / disappear setting menu of PTZ camera.
-
ENT : You can use this button when you select an item from the displayed menu mode.
-
CLR / ESC : Use when you cancel a selected item from the displayed menu mode.
-
U : Move up camera. ( or, move up cursor.)
-
D : Move down camera. ( or move down cursor.)
-
L : Move left camera. ( or , move left cursor.)
-
R : Move right camera. ( or, move right cursor.)
-
H : Go to home position.( In case of CyberScan1 and displayed menu mode, cancel selected number
in ‘TOUR SETUP’.)
-
AP: Start/Stop auto pan( In case of CyberScan1, call Auto Scan #1)
-
Focus +/-: Focus near/far.
-
Zoom +/- : Zoom in/out. ( In case of CyberScan1 and displayed menu mode, select/non number or
character)
-
Iris +/- : Iris open/close.
4. Auto-Pan (CyberScan1)
4-1. click ‘menu’ button
à
select ‘DOME SETUP’
à
select ‘AUTO SCAN’
4-2. setup each item using the ZOOM key based on the spec of the camera. For the setting of
‘START(PTZ)’ , you can set by moving of the camera using the keys of (U, D, L, R). Note) You have to
tick for ‘Diff. Operation Mode’.
