5. Periodic Inspection
5-1
5.1 Important Items at Periodic Inspection and Maintenance
The following table shows the inspection and maintenance intervals under normal operation
conditions. When used or operated under hard environmental conditions, it is impossible to warrant
the machine even if the above conditions are performed according to the intervals listed in the above
table.
Be sure to use appropriate tools for inspection and maintenance work. Inappropriate tools could
cause unexpected injury.
Please wear personal protective equipment such as a helmet, safety glasses, earplugs, safety shoes,
gloves, and a mask as appropriate to the work environment
Do not touch hot portions of the machine while inspecting the machine when running. Parts such as
the engine, exhaust manifold, exhaust pipe, exhaust muffler, radiator, inter cooler, generator, and
pipe are especially hot, so never touch those parts, because it could cause scalding.
SY001
Hang a “Under Maintenance” tag
Before starting inspection, switch off the circuit breaker of this
machine, remove the starter key from the starter switch, and
then hang a “Now Checking and under Maintenance” tag where
it can be easily seen.
The checker must keep the key during checking and
maintenance.
Remove the negative (–) side cable from the battery. If the above
procedure is neglected, and another person starts operating the
machine during check or maintenance, it could cause serious
injury.
Instructions and unspecified work prohibited
Be sure to use recommended fuel, DEF, oil, grease, or antifreeze.
Do not disassemble or adjust engine, compressor or part(s) for which inspection or maintenance is not
referred to in this manual.
Use genuine parts for replacement.
Any breakdown, caused by using unapproved parts or by wrong handling, will be out of the scope of
“WARRANTY”.
Do not pour water or steam on electrical components.
Place a container or a pan underneath the oil port to receiver waste liquid so that such liquid cannot be
spilt out on the floor or inside the machine.
Be sure that no waste liquid is disposed of on the ground. Such waste on the ground, river or lake will
cause serious environmental contamination. Be sure to follow the local regulations. If harmful materials
such as oil, antifreeze solution or filters are disposed of incorrectly, the responsible person should be
punished by the authority.
Observe local regulations when disposing of such toxic materials as oil, fuel, coolant (Antifreeze), filters,
and battery etc.
Go
to
Discount-Equipment.com
to
order
your
parts
