AirLive
POE100CAMv2
User’s
Manual
89
1.
Node:
is the serial number of this sensor of the current device.
2.
Location:
give a meaningful name to this sensor.
3.
Pattern:
There are two kinds of sensor:
General
and
Critical
. General sensor can be turned on or off by
system administrator while critical sensor can not.
4.
Default Status:
can be normal open or normal close depend on the sensor type.
5.
Enable:
check this to activate the sensor.
6. Click [OK] to save the settings and leave this dialog.
7. Click [Apply] to save the settings of this sensor, and stay in this dialog to set the other sensor nodes.
Remove Sensor
Click [Remove Sensor] to remove the selected sensor. You will be asked to confirm the deletion.
Breach
The alarm actions are the same as those for LAN camera, with two additional alarm actions: [Enable DI] and
[Disable DI]. Please refer to section 7.6.8.1.2 – Image Alarm
for detail setup procedures.
Relay (Digital Output)
Click the
button in the System Setup tree, the toolbar becomes:
The button on the right will only appear if you select a configured relay.
Relay Settings
Click [Relay Setting] button and the Relay Setting dialog will appear, as shown below:
