CHAPTER 8: SENSOR CALIBRATION
39
To Factory Reset Airdog ADII:
1. Turn on ADII by inserting the battery into the drone and long pressing (3 sec.) the
Power button (located on the battery itself).
2.Turn on AirLeash by long pressing (3 sec.) the Power/OK
button.
3. Short press the Menu
button to enter the Menu.
4. Navigate through the Menu with arrow left
or right
buttons until you see
the Settings icon on the AirLeash display.
5. Short press the Power/OK
button to enter Settings menu.
6. Navigate through the Settings menu with arrow left
or right
buttons until
you see the Factory reset
icon on the AirLeash display.
7. Short press the Power/OK button to enter the Factory reset
menu.
8. Navigate through the Factory reset menu with arrow left
or right
buttons
until you see the drone
icon.
9.Short press the Power/OK
button, a warning message: “Are you sure?” will
pop up, short press the Power/OK
button again to restart and factory reset
Airdog.
8.2 AirLeash Calibration
Please note that all AirLeash sensors have been factory calibrated. Sensors
should be recalibrated ONLY if AirLeash displays a calibration error message
during the AirLeash Preflight Check.
• If you hear the SOS tone (three long beeps followed by three short beeps) right after
you have powered AirLeash on, there is a problem with one or more AirLeash sensors.
To solve this please do a Factory Reset on AirLeash. If you don't know how to do a
Factory reset refer go to Chapter 8.1 for information.
• If you get the SOS tone (three long beeps followed by three short beeps) even after
Factory Reset, then please do the AirLeash Preflight Check, it will notify you which
sensors are failing. Note that Preflight Check requires GPS, so you have to do it outside
in a wide open space.
