CAMM
Air Monitor Corporation
116-044-91.P65 (8/31/10)
CAMM - IO&M Manual
5.4 – CONFIGURATION
The CAMM's Onboard Microprocessor Controls Configuration: Operating parameter selection; input/output activa-
tion and scaling, display scaling, and transducer calibration.
The customer can verify configuration and change certain parameters (within defined ranges) by entering the CAMM's
Configuration mode. This is accomplished using the four pushbuttons located on the CAMM's top cover.
The type (i.e., 4-20mA, 0-5V, 0-10V) of available outputs can also be changed by jumper selections on I/O board (see
Section 4.6).
To gain access to the jumpers, remove two 10-32 screws on front cover and pull the cover straight up and swing to the
right.
CAUTION:
With cover removed, ESD (electrostatic discharge) precautions should be observed at all times
to protect sensitive components.
Refer to Figure 5.1 for location of pushbuttons:
UP
,
DN
,
ESC
, and
ENT
and location of jumpers.
Figure 5.1
Figure 5.2
12
SECTION 5 – OPERATION
Summary of Contents for CAMM
Page 2: ......
