5. Immediately after engine starts, release the main switch and allow it to return to
“
ON
”(on).
NOTICE:
Never turn the main switch to “START”(start) while the engine is
running. Do not keep the starter motor turning for more than 5 seconds, If the starter
motor is turned continuously for more than 5 seconds, the battery will be quickly
discharged, thus making it impossible to start the engine. The starter can also be
damaged. If the engine will not start after 5 seconds of cranking, return the main
switch to “ON”(on), wait 10 seconds, then crank the engine again.
TIP:
⚫
When the engine is cold, it needs to be warmed up. For further information, see page
50.
⚫
If the engine is warm and fails to start, open the throttle slightly and try to start the
engine again. If the engine still fails to start. See page 87.
Checks after starting engine
Cooling water
Check for a steady flow of water from the cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the water pump is pumping water through the
cooling water passages. If the cooling water passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
NOTICE
:
If water is not flowing out of the pilot hole at all times while the engine is running,
overheating and serious damage could occur. Stop the engine and check whether
the cooling water inlet on the lower case or the cooling water pilot hole is blocked.
Consult your dealer if the problem cannot be located and corrected.