Recommended engine oil:
4-stroke outboard motor oil
Engine oil quantity (without oil filter replacement):
1.6 L (1.69 US qt, 1.41 Imp-qt)
Engine oil quantity (with oil filter replacement):
1.8 L (1.90 US qt, 1.58 Imp-qt)
TIP:
If a torque wrench is not available when you are installing the drain screw, finger tighten the
screw just until the gasket comes into contact with the surface of the drain hole. Then
tighten 1/4 to 1/2 turn more. Tighten the drain screw to the correct torque with a torque
wrench as soon as possible.
8. Add the correct amount of oil through the filler hole. Put back the filler cap and the
dipstick.
NOTICE:
Overfilling the oil could cause leakage or damage. If the oil level is
above the upper level mark, drain until the
level meets the specified capacity.
1. Oil filler cap
9. Leave the outboard motor for 5-10 minutes.
10. Remove the oil dipstick and wipe it clean.
11. Insert the dipstick and remove it again. Be sure to completely insert the dipstick into the
dipstick guide, otherwise the oil level measurement will be incorrect.
12. Recheck the oil level using the dipstick to be sure the level falls between the upper and
lower marks. Consult your dealer if the oil level is out of specified level.