INSTALLATION
MARVEL 8 MARK III
© MARVEL MFG. CO., INC. MANUAL 8SDN10871N (04/08)
A-3
4.
The coolant pump is shipped with one hose
attached with a spray nozzle on the end for
coolant flushing. The other end of this hose
is attached to a tee at the pump outlet. This
tee has an open 1/4” FNPT port. There is a
1/4” I.D. black hose attached to the table leg
closest to the pump with a 1/4” MNPT
swivel fitting on the end. This swivel fitting
must be attached to the open port at the
pump outlet as shown in the following
photo.
The coolant hose attaches to the pump outlet tee
on the pump assembly as shown above.
5.
The coolant pump is shipped with one
electrical cable assembly connected to the
pump motor with a connection plug wired
onto the opposite end. This connection plug
must be connected to the plug receptacle on
the bottom of the terminal box located inside
of the motor enclosure. This plug receptacle
can be found on the underside of the motor
enclosure and can be connected without
gaining access to the motor enclosure.
The coolant pump electrical cord attaches to the
plug receptacle on the bottom of the terminal
box under the motor enclosure as shown.
OPTIONAL EQUIPMENT
The Marvel Series 8 can be equipped with a
wide range of optional equipment. Much of this
equipment, such as special vise jaws and length
gauges, is installed for use during a specific job
and then removed. The installation and use of
this type of equipment is described in the
"Machine Description" section.
Optional Roller Tables
are available for both
the load and discharge sides of the machine. The
roller tables can be mounted on the basic
machine at anytime. Assembly instructions are
included with the optional roller table.
Digital Tilt Readout
must be set to zero. To
calibrate the digital tilt readout:
1.
Ensure that the saw blade is square (at a 90º
angle) to the level table.
2.
Press and release the button on the back of
the digital tilt readout to set the tilt to 0º.
Chip Pan
Coolant Hose (loose for
field connection)
Coolant Pump (set
in chip pan)
Coolant Chip Flush Hose
(loose for field connection)
View of Bottom Side of Motor
Enclosure Expanded Metal
Opening for Coolant Pump Cord
Coolant Pump Cord
before Field Connecting
into Terminal Box
Coolant Pan
(shown with-
out coolant)
Brass Intake
Screen
Saw Column Hose
(loose for field conn)
