MACHINE DESCRIPTION
MARVEL 8 MARK III
© MARVEL MFG. CO., INC. MANUAL 8SDN10871N (04/08)
D-3
COLUMN AUTO RETRACT SELECTOR
SWITCH
The “COLUMN AUTO RETRACT”
selector switch is a two position switch.
OFF: In the “OFF” position, the column travel
will stop after it reaches the column forward
position.
ON: In the “ON” position, the column travel
will stop after it reaches the column forward
position and then the column travel will
automatically retract to the column rear
position.
COOLANT SELECTOR SWITCH
The
“Coolant” switch is a three position switch
which controls the coolant pump. The three
positions are:
OFF: In the “OFF” position, neither the coolant
pump nor optional oil mist system will run.
ON: In the “ON” position, the coolant pump or
optional oil mist system runs continuously until
the “STOP” pushbutton is pressed.
AUTO: In the “AUTO” position, the coolant
pump or optional oil mist system runs any time
the blade is operating.
NOTE: Regardless of the coolant switch
position, coolant will not flow unless the coolant
valve is in the open position.
COOLANT SYSTEM SELECTOR SWITCH
The “COOLANT SYSTEM” switch is a two
position switch.
FLOOD: In the “FLOOD” position, the coolant
pump is enabled to operate.
MIST: In the “MIST” position, the optional oil
mist system is enabled to operate.
MESSAGE LIGHT
The message light is used
to alert the operator of problems with the saw.
A flashing light will indicate a drive fault. To
reset the fault turn the machine disconnect off
for 15 seconds.
A solid light indicates that the blade must be
tracked. Refer to the blade tracking section of
the manual.
FEED FORCE DISPLAY GAUGE
The
“FEED FORCE” display gauge indicates the
amount of force that is applied to the work piece
by the saw blade during a cut.
