INSTALLATION
MARVEL 8 MARK III
© MARVEL MFG. CO., INC. MANUAL 8SDN10871N (04/08)
A-5
LUBRICATION
The lubrication points and intervals should be
checked before operating the saw. Refer to the
Maintenance Schedule.
COOLANT SYSTEM
The coolant pump should
never be run without coolant
in the reservoir. Damage to
the coolant pump will occur.
The coolant system needs approximately 20
gallons (75 liters) of coolant, mixed according
to the coolant manufacturer's directions, poured
directly into the coolant pan.
COOLANT PUMP ROTATION
CHECK
IMPORTANT: Two people are required to
perform this check.
1.
Ensure all guards and doors are closed and
secure.
2.
Turn the main electrical disconnect switch
on.
3.
Press the start button on the saw.
4.
Have a person watch the coolant pump sight
glass and observe the shaft in the center. The
shaft will have a red mark on it.
5.
Turn the coolant pump selector switch to the
“On” position and then back to the “Off”
position. The shaft should rotate clock wise,
if so this step is done.
6.
If the coolant pump is rotating counter-clock
wise then do the following.
7.
Turn the main disconnect to the “Off”
position.
8.
Open the electrical enclosure door.
9.
Lock out the disconnect switch.
10.
Reverse the 2T1 and 2T2 wires on the
coolant pump overload (2OL).
11.
Repeat steps above.
FINAL INSPECTION
After the saw has been installed, a thorough
inspection should be performed. The following
check list will locate any items that may need
further attention.
Inspect For:
□
Loose components, guards or panels
□
Loose fasteners and fittings
□
Loose hoses and conduit
□
Missing or damaged items
□
Coolant leaks
□
Overall condition and readiness for use
CAUTION
Coolant Pump
Sight Glass
