Agrisem Big Boss, User Manual

Page: 11 / 90

11
2.13 Servicing and maintenance
Observe the prescribed intervals for periodic checks and
inspections.
Maintain the machine according to the maintenance plan;
see chapter ‘Servicing and maintenance’.
Only carry out the work described in this user manual.
Carry out maintenance and servicing work after placing the
machine on a stable floor and securing it to prevent it from
moving.
Depressurise the hydraulic system and lower the work
equipment or support it with appropriate means.
Before carrying out any work on the electrical system,
disconnect it from the power supply.
Before performing welding work on the machine, disconnect
cables from computers and other electronic components.
Mount the grounding terminal as close as possible to the
weld.
Before cleaning the machine with a high-pressure cleaner,
cover all the openings, which for safety and functional
reasons must not be penetrated by water, steam or cleaning
agents. Do not direct the water jet directly at electrical or
electronic components, bearings or the fan. When cleaning
with high pressure or steam, always keep a distance of at
least 50 cm from the machine parts.
After cleaning, check all hydraulic lines for leaks and loose
connections.
Inspect for wear from friction and abrasion. Immediately
remedy any defects found!
Tighten all loose screw connections during servicing and
maintenance work.
Do not wash new machines with steam or high-pressure
cleaners. The paint only hardens after about 3 months and
could be damaged before that.
2.14 Delivery
As a rule, the machine and tools are delivered fully
assembled on a low loader. If parts or subassemblies have
been disassembled for transport, they will be reassembled
on site by our dealer or by our fitters.
Depending on the model of low loader used, the machine
can be lowered by pulling it behind a tractor or must be
unloaded with appropriate lifting equipment (hoist or crane).

Only use lifting equipment and tools with sufficient
load-bearing capacity and approval!
2.15 Loading and unloading
Loading and unloading with a tractor.
The machine should be coupled to or uncoupled from the
tractor for loading onto or unloading from a truck.
An assistant is needed to guide the manoeuvre.
Attach or remove the transport locks.
!
Incorrect maintenance and servicing jeopardises
the operational safety of the machine. This can
lead to accidents and serious injury or death.