12
3.2.3 Slowly release clutch rod, then clutch will engage, and tiller can work at slow speed.
3.2.4 Turn accelerograph to bigger, then tiller can work on slow gear at 5km/h.
3.3 Fast gear
3.3.1 Left hand hold on clutch rod, and meanwhile press down flameout switch to disengage
clutch.
3.3.2 Right hand pull back shift gear rod, and then turn to fast gear. After shift gear, use right
hand to hold handle grip.
!NOTE: When this step, don’t hold reverse handle.
3.3.3 Slowly release clutch rod, then clutch will engage, and tiller can work at slow speed.
3.3.4 Turn accelerograph to bigger, then tiller can work on fast gear at 10km/h.
3.4 Reverse gear
3.4.1 Left hand hold on clutch rod, and meanwhile press down flameout switch to disengage
clutch.
3.4.2 Right hand pull back shift gear rod, and then turn to neutral gear. And then use right hand
to hold on reverse handle.
3.4.3 Then slowly release clutch rod, then tiller can go reverse.
!NOTE: Don’t release reverse handle. And before turn to reverse gear, must turn accelerograph to
smaller (but engine not stop, the speed is about 2000r/min). This will be more safe.
3.4.4 When no need reverse, left hand hold on clutch, and right handle release reverse handle.
3.5 When tiller is walking, don’t shift gear. First turn accelerograph to smaller, and then release
clutch, until tiller stop walking, the shift gear.
3.6 Turning. Turning handle to left or right can turn tiller.
!NOTE: When turning, don’t hold wrong handle or rod, or gears will be damaged.
3.7 Stop
3.7.1 Hold clutch rod, and meanwhile hold flameout switch to disengage clutch.
3.7.2 Turn shift gear rod to neutral, loose clutch rod, the Rotary Tiller / Rotary Weeder / Power
Weeder / Cultivator will stop working.
3.7.3 If engine need to be stopped, please see SECTION FOUR/3/2.
4. Connection of accessories
4.1 Tilling.
When need tilling, disassemble walking wheel, and then put blades onto both side of axle. And
use pin and clip to fix. After blades are assembled, must assemble dust fender. Dust fender can
protect. Tilling depth can be adjusted by deep resistance rod.
4.2 Ditching
When need do ditching work, take off deep resistance rod, adjust ditching blades height, and
then can do ditching work.
Ditching width: 40cm
Ditching depth: 11-25cm
